GRAPHTEC CE6000-120AP - Page 15

C-3
Chapter 3: Basic Operations
3.1 Raise or Lower the Tool.................................................3-2
3.2 Move the Tool Carriage and Media ........................................3-3
Move in Steps Manually ...............................................3-3
Continuously Move Manually............................................3-3
Setting of Step Movement Distance ......................................3-4
Move Away the Tool Carriage ...........................................3-5
Change the Cutting Condition (Condition No.) ..............................3-6
Reset (Revert to the initial state when the power was turned on.)................3-6
3.3 Setting the Origin Point .................................................3-7
When Coordinate Axes Rotation are Set...................................3-8
When Coordinate Axes are Rotated After Origin Point is Set...................3-8
Setting Origin Point When HP-GL is Set...................................3-9
3.4 Setting the Cutting Direction ............................................3-10
3.5 Stop Cutting.........................................................3-12
Pause and Resume Cutting ...........................................3-12
Stop Cutting........................................................3-13
Chapter 4: Convenient Functions
4.1 Settings for Cutting ....................................................4-2
Setting Cutting Area ..................................................4-2
Setting Cutting Width (EXPAND).........................................4-4
Setting Length of the Page .............................................4-5
Setting the number of pre feeds .........................................4-7
Setting paper Ready time ..............................................4-8
Setting the space rear.................................................4-9
4.2 Copy (Duplicate Cutting) ...............................................4-11
When Media Change mode is off.............................................4-11
When Media Change mode is on.............................................4-14
4.3 Panel Cutting ........................................................4-16
4.4 Setting a cross cut....................................................4-18
4.5 Setting a cut (F_CUT) for F command.....................................4-19
4.6 Setting a force for cross cut.............................................4-20
Chapter 5: Manual Position Adjust
5.1 Outline of Manual Position Adjust .........................................5-2
Alignment registration mark.............................................5-2
Example of axis adjustment ............................................5-2
5.2 Adjusting coordinate Axes ...............................................5-3
Setting the start point .................................................5-3
Chapter 6: Setting Regarding Cutting Quality
6.1 To cut the corner of thick media sharply ....................................6-2
Outline of TANGENTIAL MODE .........................................6-2
Setting the Tangential Mode ............................................6-3
Setting Length of the Overcut ...........................................6-4
Setting of the Initial Down Force.........................................6-6
6.2 Setting the Step Pass...................................................6-7
6.3 Setting the Offset Angle.................................................6-8