GRAPHTEC CE6000-120AP - Page 16

C-4
6.4 Setting the Distance Adjust .............................................6-10
6.5 Setting Initial Blade Control Position Adjust.................................6-12
6.6 Settings for OFFSET FORCE ...........................................6-14
6.7 Blade Wear Detection .................................................6-15
Checking the Wear Rate..............................................6-15
BLADE WEAR DETECT..............................................6-16
SET BLADE GROUP (blade wear group settings) ..........................6-17
BLADE WEAR SETUP (Blade wear factor settings).........................6-18
CLEAR B. WEAR VALUE (estimated distance method) ......................6-20
6.8 Adjust the space between tools 1 and 2 ...................................6-22
Chapter 7: Settings Regarding Cutting Time
7.1 Sorting the Cutting Data.................................................7-2
7.2 Perform Automatic Pre Feed When Cut Data is Received.......................7-4
7.3 Perform Automatic Pre Feed When Media is Set (Initial Feed) ...................7-6
7.4 Setting Feed Speed for Pre Feed .........................................7-8
7.5 Setting the Tool Up Speed..............................................7-10
7.6 Setting the Tool Up Move...............................................7-12
Chapter 8: Setting Regarding Interface
8.1 Setting Interface.......................................................8-2
USB Interface .......................................................8-2
RS-232C Interface....................................................8-2
Interface Setting Menu ................................................8-2
Connecting with RS-232C..............................................8-3
Setting user selection.......................................................8-3
Switching the user selection setting............................................8-4
Changing and saving the RS-232C interface setting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .8-5
8.2 Setting a separator.....................................................8-8
GP-GL Separator.....................................................8-8
HP-GL Separatorr . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8-9
8.3 Setting a timeout .....................................................8-11
Chapter 9: Settings Regarding Operation Environment
Related to Menu Display...............................................9-2
Display Language Setting (LANGUAGE SELECTION) .............................9-2
Display Length Unit Settings (LENGTH UNIT)....................................9-3
Related to Sensor ....................................................9-4
Enabling/Disabling the Media Sensors (MEDIA SENSOR) ..........................9-4
Enabling/Disabling the Push Roller Sensors (PUSH ROLLER SENSOR)...............9-5
Related to Plotter Environment ..........................................9-6
Fan Suction Setting (FAN POWER) ............................................9-6
Enabling/Disabling the Beep Setting (BEEP FOR KEY OPERATION)..................9-7
Chapter 10: Settings of Controls from Computer
Related to Command Processing .......................................10-2
Setting the Command (COMMAND)...........................................10-2
Priority of Tool Condition Selection (CONDITION PRIORITY).......................10-3