GRAPHTEC CE6000-120AP - Page 225

I-3
R
Raise or Lower the Tool .........................3-2
Reading the Screen ...........................2-22
Ready Screen ................................2-22
Removing a pen ...............................2-6
Removing the cutter plunger ......................2-5
Replacing Cutter Blade .........................11-3
Reset (Revert to the initial state when the power was turned
on.) ........................................
3-6
Rotate ......................................3-10
RS-232C interface .........................2-49, 8-2
RS-232C interface connector .....................1-4
RS-232C interface setting ........................8-5
S
Safety Precautions ...............................ii
Screen (LCD) .................................2-22
Self Diagnostic Test ..........................12-21
SELF TEST .................................12-15
Sensor .......................................9-4
Separator .....................................8-8
SETUP MANUAL ..............................1-2
SIMPLE key ..................................2-21
SIMPLE lamp ................................2-22
Simple menu ............................2-24, 2-43
Sorting the Cutting Data .........................7-2
Space between tools 1 and 2 ....................6-22
Space rear ....................................4-9
Specifications ................................ A-2
Speed ......................................2-34
Stand ....................................1-2, 1-4
Step Movement Distance ........................3-4
Step Pass ....................................6-7
Step Size ....................................10-4
Stock shaft ...................................1-4
Stop Cutting .................................3-12
Storing the Plotter .............................11-2
Structure of Cutter Plunger .......................2-2
Supplies ..................................... A-3
T
Tangential Mode ...........................6-2, 6-3
TEST .......................................2-24
Test Pattern .................................12-15
Timeout .....................................8-11
TO ENSURE SAFE AND CORRECT USE ......... i, 1-2
Tool ....................................2-4, 2-31
Tool carriage ..................................1-3
Tool Condition ...........................2-29, 2-30
Tool Up Move ................................7-12
Tool Up Speed ................................7-10
Troubleshooting ...............................12-2
U
USB cable ....................................1-2
USB interface .................................8-2
USB interface connector .........................1-4
User selection ................................2-47
User selection setting ...........................8-4