2-50
Supplement
Match it to the software you are using.
5 Press the POSITION ( ) keys and increase or decrease
the setting value.
6 Confirm the settings and press the POSITION ( ) key
(PREVIOUS).
The baud rate is selected and it will return to RS-232C setting screen.
7 Press [2] key (DATA BIT).
DATA BIT setting screen is displayed.
Supplement
Match it to the software you are using.
Press the POSITION ( ) key (PREVIOUS) to
return to the RS-232C setting screen without
changing any settings.
8 Press [1] key (8 BIT) or [2] key (7 BIT).
Data length is set, and it will return to RS-232C setting screen.
9 Press [3] key (PARITY).
PARITY setting screen is displayed.
Supplement
Match it to the software you are using.
Press the POSITION ( ) key (PREVIOUS) to
return to the RS-232C setting screen without
changing any settings.
10 Press [1] key (NONE), [2] key (EVEN), or [3] key (ODD).
The parity is selected and it will return to RS-232C setting screen.
11 Press [4] key (HANDSHAKE).
HANDWIRE setting screen is displayed.
To Next Page
Loading...
