GRAPHTEC FC8000-75 - Page 99

FC8000-UM-251-9370 8-5
8. TROUBLESHOOTING
Error
code
Error Display Cause Verication item Solution
E01017
E01017 HARDWARE
X POSITION ALARM
POWER OFF THEN ON
Loadonthe
motorwastoo
large.
Checkthemadia. Donotuseheavymedia.
Usetheprefeed
function.
Cutting
conditionsdonot
suitthecutting
medium.
Cuttingconditions. Lowerthecutting
SPEEDand/orthe
cuttingFORCE.
Movementof
theXisbeing
obstructed.
Isthereanything
blockingtheX
movement?
Turnofftheplotter,
removetheobstacle,
thenturntheplotterback
on.
Excessiveload
iscausingthe
currenttothe
motortoexceed
theratedvalue.
(1) DoestheXmove
smoothly?
No.....Checkandadjust
theXbelttension
andXmotorbelt
tension.
Yes....Verifyitem(2).
(2) IstheXexible
cablesecurely
connected?
 OrIstheXexible
cablebroken?
No.....Connectit
securely.
Yes....ReplacetheX
exiblecableif
defective.
Motor (3) DoestheX-motor
turnsmoothly?
No.....Replacethe
X-motorif
defective.
Yes....Replacethemain
boardifdefective.