GRAPHTEC FC8600 SERIES - Page 156

6-4
6-5
Next page
13
Press the [2] key (NUMBER OF POINTS).
NUMBER OF POINTS setting screen is displayed.
Supplement
It will return to MARK SCAN MODE screen
without changing the settings when you press the
POSITION (
◄
) key (CANCEL).
14
Press the [1] key (2POINT), the [2] key (3POINT), or the [3] key
(4POINT).
POINTS is selected and it will return to MARK SCAN MODE screen.
Supplement
It will return to ARMS setting screen (1/4) without
changing the settings when you press the
POSITION (
◄
) key (CANCEL).
15
Confirm the setting and press the [ENTER] key (SET).
Setting will be set, and it will return to ARMS setting screen (1/4).
16
Press the [MENU] key.
ARMS SETTING screen (1/4) is displayed.
17
Press the [2] key (MANUAL READ MARKS).
Following message is displayed.
Supplement
Tool carriage will move faster when the [FAST] key
is pressed simultaneously with the POSITION key.
18
Press the POSITION (
▲▼◄►
) key and move the tool to the
position of the adjustment mark specified by the message.
POSITION
Supplement
Repeat steps 14 and 15 if following message
prompting to move to the adjustment mark is
displayed.
Number to repeat steps 14 and 15 differs
depending on the specified number of the
adjustment marks. Follow the message that is
displayed.
It will return to ARMS setting screen (1/4)
without scanning when the [4] key (CANCEL) is
pressed.
l
l
l
19
Confirm the position of the tool, and if it is OK, press the [ENTER]
key.
Once all the adjustment marks are specified, DISTANCE entry screen is
displayed.