6-6
Supplement
Measured distance is displayed in the top line in
the DISTANCE input screen. Input value (initially
same as measured value) is displayed under
that.
If the input value is not changed, it will assume
that there is no difference between measured
distance and the distance in the data.
Digits of settings can be changed by pressing
the [FAST] key.
l
l
l
20
Press the POSITION (
▲▼
) key to set the original distance on
the data.
Supplement
It will return to default screen without changing
the settings when you press the POSITION (
◄
)
key (PREVIOUS).
DISTANCE
input screen for point 3 is displayed
if it is set to 3POINTS or more, so repeat steps
9 and 10 to set.
l
l
21
Confirm the setting and press the [ENTER] key (SET).
It will return to default screen once all the distance is set.
To Next Page
Loading...
