4-16
3
Press the [COPY] key.
COPY MODE screen is displayed.
4
Press the [1] key (MEDIA CHANGE MODE).
MEDIA CHANGE MODE setting screen is displayed.
5
Press the [1] key (OFF).
Confirm the settings and return to the COPY MODE scre
Supplement
The upper limit of copy number is 100.
The initial value for the number of copies is
always 1.
l
l
6
Press the [2] key (NUMBER OF COPIES).
NUMBER OF COPIES setting screen is displayed.
7
Press the POSITION (
▲▼
) key and increase or decrease the
setting value.
8
Confirm the setting and press the POSITION (
◄
) key
(PREVIOUS).
Copy space will be selected, and it will return to COPY mode
screen.
9
Press the [3] key (COPY MODE SET). (Setting is enabled only
when the media replacement mode is disabled.)
The COPY MODE setting screen is displayed.
Supplement
To set copy times and copy mode, turn off
"Media exchange mode".
"NO DATA FOR COPY IN BUFFER!" is
displayed if there is no data in the buffer
memory. Send the cutting data.
If too much data is sent from the buffer memory,
"COPY MODE BUFFER FULL!" will be
displayed.
If the data to be copied is larger than the
cutting area, "CANNOT COPY CUT AREA TOO
SMALL!" will be displayed.
l
l
l
l
Supplement
"CANNOT COPY CUT AREA TOO SMALL!" is
displayed if the cutting area is smaller than the
copy data. Either expand the cutting area, or set
the media that is big enough to copy.
Next page
Supplement
Copy interval can be set when MEDIA CHANGE
MODE is turned off.
Copy space can be set from 1.0 mm to 50.0
mm.
This setting is maintained even if the power is
turned off.
l
l
l
To Next Page
Loading...
