GW Instek GSP-9300 - Display the Date and Time on the Screen; Using the Wake-Up Clock

BASIC OPERATION
119
Display the Date and Time on the Screen
Description
Enables or disables the date and time on the
screen.
Operation
1. Press
System
>Date/Time[F4]>Clock[F4] and turn
the clock display on or off.
Using the Wake-Up Clock
Description
The GSP-9300 has a wake-up clock to allow the
spectrum analyzer to automatically turn on at a
set time.
Operation
1. Press
System
>Date/Time[F4]>Wake-Up Clock[F3]
and set the following parameters:
Select Clock[F1]
Choose a wake-up clock
(1~7).
State[F2]
Turns the selected clock
on/off.
Hour[F3]
Set the wake-up hour
Minute [F4]
Set the wake-up minute.
Repeat Single[F5]
Set the wake-up clock to
repeat or single.
Note
Only single days can be configured for the wake-up
clock.