GW Instek GSP-9300 - GSP-9300 Default Settings

APPENDIX
285
GSP-9300 Default Settings
The following default settings are the factory configuration settings
for the spectrum analyzer (Function settings/Test settings).
Frequency
Center Frequency: 1.5GHz
Start Frequency: 0Hz
Stop Frequency: 3GHz
CF Step: Auto
Frequency Offset: 0Hz
Span
Span: 3GHz
Amplitude
Reference level: 0.00dBm
Attenuation: Auto
Scale Div: 10
Scale: Off
Y Axis: dBm
Scale Type: Log
Reference level offset:
0.00dBm
Correction: Off
Input Z: 50Ω
Input Z calibration: 6.000dB
Preamp: Bypass
Autoset
Amp.Floor: Auto
Span: Auto
BW/AVG
RBW: Auto
VBW: Auto
VBW/RBW: N/A
Average: Off
Average Power: Log Power
EMI Filter: Off
Sweep
Sweep Time: Auto
Sweep: Continuous
Gated Sweep Mode: Off
Gate Delay: 50ms
Gate Length: 540ms
Sweep Control: Norm
Trace
Activated traces: trace 1
Trace Type: Clear and Write
Trace Math: Off
Detection: Auto, Normal
Display
Window Setup: Spectrum
LCD Brightness: Hi
LCD Backlight: On
Display Line, -50.0dBm, Off