GW Instek GSP-9300 - Limit Line Testing

GSP-9300 User Manual
218
EMS Test
Description
The EMS Test function allows you to debug
immunity (susceptibility) of a DUT using the
GW Instek EMI-M probes. The test function is
designed to output a frequency sweep of a user-
defined range with a user-defined signal
strength.
Example Setup
The test setup is simple. Power up the DUT and
scan the DUT with the probe. Observe the DUT
for any abnormal response from the signal
output by the probe.
DUT
probe
GSP
TG out
Operation
1. Press
EMC
Pretest
> EMS Test[F6].
2. Press SRC FreqStart[F2] and set the start
frequency of the sweep.
Start Freq.
0Hz - 3GHz
3. Press SRC FreqStop[F3] and set the stop
frequency of the sweep. The stop frequency
must be 100Hz greater than the start frequency.
Start Freq.
100Hz - 3GHz