EasyManuals Logo

GW Instek GSP-9300 User Manual

GW Instek GSP-9300
342 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #67 background imageLoading...
Page #67 background image
BASIC OPERATION
65
Note
RBW, VBW and sweep settings are reset to Auto
when the Autoset function is used.
Limiting the Autoset Vertical Search Range
You can set the amplitude floor so that the
signals lower than the setting will be ignored
by the Autoset search.
1. Press
Autoset
> Amp.Floor[F2] and switch the
range from Auto to Man.
2. Enter the amplitude limit and unit for the
Autoset search.
Range:
60 to +20dBm
Note
See page 50 for setting the amplitude units.
Limiting the Autoset Horizontal Search Range
You can change the frequency span limit in the
display to get a better view of the Autoset
result. By default, the frequency span after
Autoset is set at 3MHz.
1. Press
Autoset
> Span[F3] and switch the range
from Auto to Man.
2. Enter the span frequency for the Autoset
search.
Manual Range:
100Hz to 3GHz

Table of Contents

Other manuals for GW Instek GSP-9300

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the GW Instek GSP-9300 and is the answer not in the manual?

GW Instek GSP-9300 Specifications

General IconGeneral
BrandGW Instek
ModelGSP-9300
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals