GSP-9300 User Manual
136
The MAX and MIN measurements are held until
higher or lower values are found. To reset the MAX
and MIN measurements, press
>
Demod[F2]>AM Analysis[F1]>Min/Max Reset[F3].
AM Pass Fail Testing
The Limit Edit function puts a pass limit on the
AM depth, carrier offset and carrier power.
> Demod[F2]>AM Analysis[F1]>
Limit Edit[F5] and set the limits.
If the measured depth is
above this limit, it will be
judged as Fail.
If the measured carrier
offset is above this limit,
it will be judged as Fail.
If the measured carrier
power is above this limit,
it will be judged as Fail.
2. Press Pass/Fail and turn Pass/Fail on.
To Next Page
Loading...
Need help?
General
