GW Instek GSP-9300 - Configure the WLAN Interface

GSP-9300 User Manual
270
Reset LAN
It may be necessary to reset the LAN
configuration settings before the LAN can be
used.
1. Press
System
>More[F7]>RmtInterface
Config[F1]>LAN Reset[F3] to reset the LAN.
2. The GSP-9300 will now automatically reboot.
Note
Each time the LAN is reset, the default
password is restored.
Default password: lxiWNpwd
Configure the WLAN Interface
The WLAN settings operate using any standard 3G USB modem.
For remote locations, using a 3G modem allows you to access the
GSP-9300 web server or to control the GSP-9300 via remote control
commands.
Background
To use the GSP-9300 as a server using a 3G
modem, you must first obtain a fixed IP address
from a network provider. Each provider will
assign different fixed IP addresses.
WLAN
configuration
Settings
IP Address
Default Gateway
Subnet Mask
DNS Server