GW Instek GSP-9300 - Page 147

ADVANCED OPERATION
145
ASK measurements
Wave view
Symbol view
4. Press Symbol Rate[F2] and set the Symbol rate.
 The symbol rate determines the number of symbols
for a unit of time.
Display View
5. To toggle the top half of the screen between the
Symbol view or Wave view, press
View[F4]>Symbol[F1] or View[F4]>Wave[F2].
6. If the View is set to Wave, press Time Axis [F5]
to set horizontal axis parameters:
Ref. Value[F1]
Sets the starting time on
the time axis.
Ref. Pos[F2]
Shifts the waveform X
number of grid
subdivisions.
Scale/Div[F3]
Sets the grid division
scale when Auto Scale is
Off.
Auto Scale[F4]
Toggles auto-scaling
on/off.