GETTING STARTED
33
>More 1/2[F7]>Upgrade[F2].
6. The spectrum analyzer will automatically find
the firmware on the USB flash drive and start
to update the firmware. When finished, the
message “Upgrade is finished” will be shown
at the bottom of the screen followed by
“Rebooting”.
7. The system will automatically restart after the
rebooting message.
The upgrade process may take a few minutes.
Restoring Default Settings
The factory default settings or user presets can
be easily restored using the Preset key on the
front panel. By default, the factory default
settings are restored with the Preset key.
For details on how to configure the preset
settings, please see page 121.
.
2. The spectrum analyzer will load the preset
settings.
To Next Page
Loading...
Need help?
General
