GW Instek GSP-9300 - Page 84

GSP-9300 User Manual
82
Hold Max/
Hold Min
The maximum or minimum
points are maintained for the
selected trace. The trace points
are updated each sweep if new
maximum or minimum points
are found. The Hold Max
setting also has a threshold
setting. This setting will ensure
only those values above the
threshold are kept.
View
View will hold the selected
trace and stop updating the
trace data for the selected trace.
Pressing View[F5] will display
the trace data that was cleared
using the Blank[F6] key.
Blank
Clears the selected trace from
the display and stores trace
data. The trace can be restored
by pressing View[F5].
Display Icon
Example
View
Hold Max
View
Blank
Trace 1
Trace 2
Trace 3
Trace 4
Operation
1. Press
Trace
> Trace[F1] and choose the trace
number.
Trace:
1, 2, 3, 4