Haas VF Series Service Manual

1-15-96 96-8100
HAAS AUTOMATION, INC.
109
MECHANICAL SERVICE
SERVICE MANUAL
VF-SERIES
14. ENCLOSURE REPLACEMENT
PLEASE READ THIS SECTION IN ITS ENTIRETY BEFORE ATTEMPTING TO REPLACE THE DOORS OR WINDOWS.
TOOLS REQUIRED:
TRIM INSTALLATION TOOL
(DULL-EDGED KNIFE OR CAULKING SPATULA)
14.1 DOOR REPLACEMENT
CAUTION! If possible, have two people performing this operation, as the weight of the doors may be a factor in
removal.
REMOVAL -
1. Turn the machine power off.
2. Slide the doors to the full open position.
3. Remove the tension springs (2) connecting the two swivel roller brackets at the top and bottom of the door.
4. Slide the door to the fully closed position. Loosen the two upper roller hex nuts, and disengage the upper swivel
roller brackets from the top roller guide.
5. Lift the door from the bottom roller guide and remove.
INSTALLATION -
6. Ensure that the lower roller hex fasteners are wrench tight and the upper roller fasteners are finger tight in the
middle of their adjusting slots. Place the door into the enclosure, and position with the lower rollers resting on the
lower roller guide.
7. Rotate the door to the upright position, and engage the top rollers onto the top roller guide.
8. Replace the tension springs onto the upper and lower roller swivel brackets. Tighten the upper roller fasteners.
9. Verify that the door travels smoothly. If it does not:

Haas VF Series Specifications

General

Machine Type	Vertical Machining Center
Control	Haas CNC Control
Z-Axis Travel	20-30 inches (varies by model)
Y-Axis Travel	16 - 30 inches (varies by model)
Spindle Motor	20-30 hp (depending on model)
Tool Capacity	20-40 tools (varies by model)