Haas VF Series Service Manual

96-8100 1-15-96
182
PARAMETERS
SERVICE MANUAL
VF-SERIES
Parameter 43 A SWITCHES
See Parameter 1 for description AND make sure that this parameter is
set to enable the fourth axis before you try to enable the fourth axis from
settings.
Parameter 44 A P GAIN
See Parameter 2 for description.
Parameter 45 A D GAIN
See Parameter 3 for description.
Parameter 46 A I GAIN
See Parameter 4 for description.
Parameter 47 A RATIO (STEPS/UNIT)
See Parameter 5 for description.
Parameter 48 A MAX TRAVEL (STEPS)
See Parameter 6 for description.
Parameter 49 A ACCELERATION
See Parameter 7 for description.
Parameter 50 A MAX SPEED
See Parameter 8 for description.
Parameter 51 A MAX ERROR
See Parameter 9 for description.
Parameter 52 A FUSE LEVEL
See Parameter 10 for description.
Parameter 53 A BACK EMF
See Parameter 11 for description.
Parameter 54 A STEPS/REVOLUTION
See Parameter 12 for description
Parameter 55 A BACKLASH
See Parameter 13 for description.
Parameter 56 A DEAD ZONE
See Parameter 14 for description.
Parameters 57 through 128 are used to control other machine dependent functions. They are:
Parameter 57 COMMON SWITCH 1
Parameter 57 is a collection of general purpose single bit flags used to turn
some functions on and off. The left and right cursor arrows are used to select
the function being changed. All values are 0 or 1 only. The function names are:

Haas VF Series Specifications

General

Machine Type	Vertical Machining Center
Control	Haas CNC Control
Z-Axis Travel	20-30 inches (varies by model)
Y-Axis Travel	16 - 30 inches (varies by model)
Spindle Motor	20-30 hp (depending on model)
Tool Capacity	20-40 tools (varies by model)