1-15-96 96-8100
HAAS AUTOMATION, INC.
43
MECHANICAL SERVICE
SERVICE
MANUAL
VF-SERIES
INSTALLATION -
1. Protect table surface with a piece of cardboard.
2. Replace each side cover from the top side with seven SHCS. Jog Z-axis as necessary to make access to screws
easier.
CAUTION! Be careful not to run the head covers into the enclosure.
3. Reconnect tool release cable, if equipped, then replace front cover from the bottom and attach with eight SHCS.
4. Replace rear cover, and attach to side covers with six SHCS.
5. Replace top cover, and attach to side covers with four SHCS.
To Next Page
Loading...
