HIKVISION DS-K1T804A Series - Configure RS-485 Parameters; Security Mode Settings

All device parameters will be restored to the default ones. The
device should be acvated aer restoring.
Upgrade
On the Device for Management page, click Remote Conguraon
→ System → System Maintenance to enter the System
Maintenance tab.
Select a device type from the drop-down list, click Browse and
select an upgrade le from the local computer, and click Upgrade.
Note
•
If you select Card reader as the device type, you should also
select a card reader No. from the drop-down list.
•
The upgrade will lasts for about 2 min. Do not power o during
the upgrading. Aer upgrading, the device will reboot
automacally.
9.5 Congure RS-485 Parameters
You can set the RS-485 parameters including the baud rate, data
bit, stop bit, parity type, communicaon mode, work mode, and
connecon mode.
Steps
1.
Click Maintenance and Management → Device to enter the
device list.
2.
Click
to enter the remote conguraon page.
3.
Click System → RS-485
Sengs to enter the Conguring the
RS-485 Parameters tab.
4.
Select the serial No. of the port from the drop-down list to set
the RS-485 parameters.
5.
Set the baud rate, data bit, the stop bit, parity,
ow control,
communicaon mode, working mode, and the connecon
mode from the drop-down list.
6.
Click Save and the
congured parameters will be applied to the
device automacally.
Note
Aer changing the working mode, the device will be rebooted.
A prompt will be popped up aer changing the working mode.
9.6 Security Mode Sengs
Set the security mode for logging in the client soware.
On the Device for Management page, click → System →
Security to enter the Security Mode tab.
Select a security mode from the drop-down list, and click Save.
You can also enable SSH or HTTP to get a more secure network.
Security Mode
High security level for user informaon vericaon when
logging in the client
soware.
Compable Mode
The user informaiton vericaon is compable with the old
client soware version when logging in.
98