HIKVISION DS-K1T804A Series - Configure Wi-Fi; Set Relay Parameters; Set Access Control Parameters; Configure Volume Input or Output

Aer creang the EHome informaon, you can add the device via
EHome protocol.
9.10 Congure Wi-Fi
Steps
1.
On the Device for Management page, click
→ Network →
Wi-Fi to enter the Wi-Fi Sengs tab.
2.
Check Enable to enable the Wi-Fi funcon.
3.
Enter the SSID name and password or you can select a network
from the Wi-Fi list.
4.
Set the Wi-Fi Security Mode from the drop-down list.
5.
Oponal: Click Refresh to refresh the network status.
6.
Oponal: Set WLAN parameters.
1) On the Wi-Fi Sengs page, click WLAN to enter the WLAN
page.
2) Uncheck DHCP and set the IP address, the subnet mask, the
default gateway, the MAC address, the DNS1 IP Address, and
the DNS2 IP address.
7.
Click Save.
9.11 Set Relay Parameters
Click Maintenance and Management → Device to enter the
device list.
Click
to enter the remote conguraon page.
Click Alarm → Relay . Select a relay and click
and set the
relay name and output delay
me. Click OK to save the sengs.
9.12 Set Access Control Parameters
Steps
1.
On the Device for Management page, click
→ Others →
Access Control Parameters to enter the Access Control
Parameters tab.
2.
Check the checkbox to enable the
funcon.
Voice Prompt
If you enable this funcon, the voice prompt is enabled in
the device. You can hear the voice prompt when operang in
the device.
3.
Click Save.
9.13 Congure Volume Input or Output
Steps
1.
On the Device for Management page, click
→ Image →
Audio Input or Output to enter Audio Input or Output tab.
2.
Move the block to adjust the device input and output volume.
3.
Click Save.
9.14 Operate Relay
Steps
1.
Click Maintenance and Management → Device to enter the
device list.
100