HIKVISION DS-K1T804A Series - Person Management; 7.5.1 Add Person

Move the cursor and select Set and select a template from
the list.
Note
For details about eding template, see Set Schedule
Template.
Auth.
Select an authencaon mode when verifying user's
permission.
Note
•
If you select the authencaon mode as Controller, you
should set the authencaon mode in Set Access Control
Parameters. The system will authencate user's identy
according to the congured authencaon mode. By
default, the
authencaon mode is Controller. This mode
is applicable to edit users' authencaon modes in batch.
•
If an user needs to use a special authencaon mode,
which is dierent from the authencaon mode
congured in Set Access Control Parameters, he can use
card/ngerprint, card, etc. The system will authencate
the user's identy according to the congured
authencaon mode rst. This mode is applicable to edit
single user's authencaon mode, which has special
permissions.
Role
Select the user's role as administrator or normal user.
•
Admin: The admin has all permissions to operate the device.
•
User: The normal user can check aendance on the inial
page.
Note
•
All persons can enter the main page by entering the
device password to operate if there is no admin user
congured.
•
Aer conguring the admin, you should authencate the
admin to enter the main page.
•
You can use the USB interface to import the user
informaon. For details, see Data Transfer.
3.
Press ESC, and select Yes to save the
sengs and exit the page.
7.3 Local Login
Log in the device as an administrator to mange the device
parameters, including the communicaon, the user, the access
control parameters, the
aendance, the me, the report, the
system, etc.
Hold OK for 3 s to enter the login page. Select FP, Device PWD, or
Card, and authencate to enter the home page.
13