HIKVISION DS-K1T804A Series - Page 27

Note
•
The ID refers to the user aendance serial No.
•
The ID should be between 1 and 99999999 and should
not start with 0.
•
The ID should be used for once.
Name
Enter the new user name.
Note
•
Press the up or down key on the keypad to change the
input method.
•
Up to 64 characters are allowed in the user name.
Card
Set: Swipe card on the card swiping area or enter card No.
manually, and select a card property.
View Info.: View the user's added card informaon.
Note
•
The card No. is required.
•
Up to 20 digits can be contained in the card No.
•
The card No. can be 0.
•
The card No. can start with 0 when it contains more than
one numbers. E.g. 012345.
•
The card No. should be used for once.
•
If device does not support swiping card, you should enter
the card No. manually. If you need to enter the card No.
manually, you should enable Press Key to Input Card No..
For details, see
Congure Parameters for Access Control
Device.
FP (Fingerprint)
On the Fingerprint page, select a target nger and record
according to the voice prompt.
Note
•
The same ngerprint cannot be repeatedly added.
•
Up to 10 ngerprints can be added to one user.
•
You can also scan the ngerprints via the external
ngerprint recorder and apply the ngerprints to the
device by the client soware.
•
For detailed informaon about scanning the ngerprint,
see Tips for Scanning Fingerprint.
Dept. (Department)
Select a department in the list and edit the department.
Note
For detailed informaon about eding the department, see .
Plan (Template)
12