The audible warning of access control device will be
triggered.
Buzzer on Reader
The audible warning of card reader will be triggered.
8.
Click Save.
When the card
(congured in Step 5) swipes on the card reader
(congured in Step 6), it can trigger the linked acons
(congured in step 7).
9.
Oponal: Aer adding the device linkage, you can do one or
more of the following:
Delete
Linkage
Sengs
Select the congured linkage sengs in the
device list and click Delete to delete it.
Edit Linkage
Sengs
Select the congured linkage sengs in the
device list and you can edit its event source
parameters, including event source and
linkage target.
8.6.4 Congure Device Acons for Person ID
You can set the access control device's linkage acons for the
specied person ID. When access control device detects the
specied person ID, it can trigger the alarm output, host buzzer,
and other acons on the same device.
Steps
Note
It should be supported by the device.
1.
Click Access Control → Linkage Conguraon .
2.
Select the access control device from the list on the
le.
3.
Click Add buon to add a new linkage.
4.
Select the event source as Person Linkage.
5.
Enter the employee number or select the person from the
dropdown list.
6.
Select the card reader where the card swipes to trigger the
linked
acons.
7.
In the Linkage Target area, set the property target to enable
this
acon.
Buzzer on Controller
The audible warning of access control device will be
triggered.
Buzzer on Reader
The audible warning of card reader will be triggered.
8.
Click Save.
9.
Oponal: Aer adding the device linkage, you can do one or
more of the following:
Delete
Linkage
Sengs
Select the congured linkage sengs in the
device list and click Delete to delete it.
Edit Linkage
Sengs
Select the congured linkage sengs in the
device list and you can edit its event source
72