HIKVISION DS-K1T804A Series - Configure Schedule and Template; Add Holiday

Select the model of the connected card enrollment staon
Note
Currently, the supported card enrollment staon model is DS-
K1F180-D8E.
Card Type
Select the card type as EM card or IC card according to the
actual card type.
Buzzing
Enable or disable the buzzing when the card number is read
successfully.
Card No. Type
Select the type of the card number according to actual needs.
M1 Card
Encrypon
If the card is M1 card, and if you need to enable the M1 Card
Encrypon funcon, you should enable this funcon and select
the sector of the card to encrypt.
Remote Mode: Issue Card by Card Reader
Select an access control device added in the client and swipe the
card on its card reader to read the card number.
8.3 Congure Schedule and Template
You can congure the template including holiday and week
schedule. Aer seng the template, you can adopt the
congured template to access groups when seng the access
groups, so that the access group will take
eect in the me
duraons of the template.
Note
For access group sengs, refer to Set Access Group to Assign
Access Authorizaon to Persons.
8.3.1 Add Holiday
You can create holidays and set the days in the holidays, including
start date, end date, and holiday
duraon in one day.
Steps
Note
You can add up to 64 holidays in the soware system.
1.
Click Access Control → Schedule → Holiday to enter the
Holiday page.
2.
Click Add on the
le panel.
3.
Create a name for the holiday.
4.
Oponal: Enter the descripons or some nocaons of this
holiday in the Remark box.
5.
Add a holiday period to the holiday list and
congure the
holiday duraon.
Note
Up to 16 holiday periods can be added to one holiday.
55