HIKVISION DS-K1T804A Series - 7.6.2 Set Access Control Parameters

alarm, and the authencaon mes exceeded, and the super
password.
Holiday (Holiday Group)
Congure the holiday group for the access control funcon. In
the seng duraon, the aendance will be failed and the door
cannot be controlled.
WK. Plan (Week Plan)
Congure the week plan for the access control funcon. The
door can be controlled during the
congured me.
Template (Schedule Template)
Set the congured week plan and the holiday group. The door
can be controlled in the congured me duraon.
7.6.2 Set Access Control Parameters
Set the device's access control parameters, including the device
authencaon, the sub reader authencaon, the door contact
status, the open duraon, the door-open meout alarm, and the
authencaon mes exceeded, and the super password.
On the Home page, move the cursor and select ACS (Access
Control Sengs) to enter the Access Control Sengs page. Edit
the access control parameters on this page.
Figure 7-7 Access Control Parameters
The available parameters descripons are as follows:
Table 7-1 Access Control Parameters
Descripons
Parameter Descripon
Terminal Auth
Select the face recognion
terminal's authencaon mode. You
can also customize the
authencaon mode.
Note
•
Only the device with the
ngerprint module supports the
ngerprint related funcon.
•
Biometric recognion products
are not 100% applicable to an-
spoong
environments. If you
require a higher security level,
20