HIKVISION DS-K1T804A Series User Manual

5.
Set the parity mode according to the property of the third
party card reader.
Note
•
Up to 80 bits are allowed in the total length.
•
The odd parity start bit, the odd parity length, the even
parity start bit and the even parity length range from 1 to 80
bit.
•
The start bit of the card ID, the manufacturer code, the site
code, and the OEM should range from 1 to 80 bit.
6.
Set output transformaon rule.
1) Click Set Rule to open the Set Output Transformaon Rules
window.
Figure 8-2 Set Output Transformaon Rule
2) Select rules on the le list.
The selected rules will be added to the right list.
3) Oponal: Drag the rules to change the rule order.
4) Click OK.
5) In the Custom Wiegand tab, set the rule's start bit, length,
and the decimal digit.
7.
Click Save.
8.5.4
Congure Card Reader Authencaon Mode
and Schedule
You can set the passing rules for the card reader of the access
control device according to your actual needs.
Steps
1.
Click Access Control → Advanced
Funcon → Authencaon
to enter the authencaon mode conguraon page.
2.
Select a card reader on the le to congure.
3.
Set card reader authencaon mode.
1) Click Conguraon.
65

HIKVISION DS-K1T804A Series Specifications

General

Brand	HIKVISION
Model	DS-K1T804A Series
Category	IP Access Controllers
Language	English