HIKVISION DS-K1T804A Series - 8.2.6 Configure Access Control Information

3.
In the Credenal → Fingerprint panel, click +.
4.
In the pop-up window, select the collecon mode as Remote.
5.
Select an access control device which supports ngerprint
recognion funcon from the drop-down list.
6.
Collect the
ngerprint.
1) Click Start.
2) Place and li your ngerprint on the ngerprint scanner of
the selected access control device to collect the ngerprint.
3) Click Add to save the recorded ngerprint.
7.
Conrm to add the person.
-
Click Add to add the person and close the Add Person
window.
-
Click Add and New to add the person and connue to add
other persons .
Note
Once the ngerprint is added, the ngerprint type cannot be
changed.
8.2.6 Congure Access Control Informaon
When adding a person, you can set her/his access control
properes, such as seng the person as visitor or as blacklist
person, or as super user who has super
authorizaon.
Steps
1.
Enter Person module.
2.
Select an organizaon in the organizaon list to add the person
and click Add.
Note
Enter the person's basic informaon rst. For details about
conguring person's basic informaon, refer to Congure Basic
Informaon.
3.
In the Access Control panel, set the person's access control
properes.
PIN Code
The PIN code must be used aer card or ngerprint when
accessing. It cannot be used independently. It should contain
4 to 8 digits.
Device Operator
For person with device operator role, he/she is authorized to
operate on the access control devices.
Note
The Super User, Extended Door Open Time, Add to Blacklist,
and Mark as Visitor funcons cannot be enabled concurrently.
For example, if one person is set as super user, you cannot
enable extended door open me for her/him, add her/him to
the blacklist, or set her/him as visitor.
4.
Conrm to add the person.
-
Click Add to add the person and close the Add Person
window.
50