4) Drag the cursor to draw the me duraon, which means in
that duraon of me, the congured access group is
acvated.
Note
Up to 8 me duraons can be set to one holiday period.
5) Perform the following operaons to edit the me duraons.
•
Move the cursor to the
me duraon and drag the me
duraon
on the meline bar to the desired posion when
the cursor turns to .
•
Click the me duraon and directly edit the start/end me
in the appeared dialog.
•
Move the cursor to the start or the end of me duraon and
drag to lengthen or shorten the me duraon when the
cursor turns to .
6) Oponal: Select the me duraon(s) that need to be
deleted, and then click in the Operaon column to delete
the selected
me duraon(s).
7)
Oponal: Click in the Operaon column to clear all the
me duraon(s) in the me bar.
8)
Oponal: Click in the Operaon column to delete this
added holiday period from the holiday list.
9) Click Save.
5.
Oponal: Click Copy to to copy the door status sengs of this
door to other door(s).
8.5.3
Congure Custom Wiegand Rule
Based on the knowledge of uploading rule for the third party
Wiegand, you can set mulple customized Wiegand rules to
communicate between the device and the third party card
readers.
Before You Start
Wire the third party card readers to the device.
Steps
Note
•
By default, the device disables the custom wiegand funcon. If
the device enables the custom Wiegand funcon, all wiegand
interfaces in the device will use the customized wiegand
protocol.
•
Up to 5 custom Wiegands can be set.
•
For details about the custom Wiegand, see Custom Wiegand
Rule
Descripons.
1.
Click Access Control → Advanced Funcon → Custom
Wiegand to enter the Custom Wiegand page.
2.
Select a custom Wiegand on the
le.
3.
Create a Wiegand name.
Note
Up to 32 characters are allowed in the custom Wiegand name.
4.
Click Select Device to select the access control device for
seng the custom wiegand.
64
To Next Page
Loading...
Need help?
General
