HIKVISION DS-K1T804A Series User Manual

Figure 7-36 Device Page
8 Client Soware Conguraon
8.1 Add Device
The client provides three device adding modes including by IP/
domain, IP segment, and ISUP protocol. The client also supports
imporng mulple devices in a batch when there are large
amount of devices to be added.
8.1.1 Add Online Device
The acve online devices in the same local subnet with the client
soware will be displayed on the Online Device area. You can
click Refresh Every 60s to refresh the
informaon of the online
devices.
Add Single Online Device
You can add single online device to the client soware.
Steps
1.
Enter the Device Management module.
2.
Oponal: Click on the right of Device Management and
select Device.
3.
Click Online Device to show the online device area.
The searched online devices are displayed in the list.
4.
Select an online device from the Online Device area.
Note
For the inacve device, you need to create the password for it
before you can add the device properly. For detailed steps,
refer to Acvaon.
5.
Click Add to open the device adding window.
6.
Enter the required
informaon.
Name
Enter a descripve name for the device.
Address
The IP address of the device is obtained automacally in this
adding mode.
Port
The port number is obtained automacally.
User Name
By default, the user name is admin.
Password
39

HIKVISION DS-K1T804A Series Specifications

General

Brand	HIKVISION
Model	DS-K1T804A Series
Category	IP Access Controllers
Language	English