HIKVISION DS-K1T804A Series - Add Shift

Each Check-In/Out
Each check-in me and check-out me is valid and the sum
of all periods between adjacent check-in and check-out me
will be recorded as the valid working duraon.
You need to set Valid Authencaon Interval for this
calculaon method. For example, if the interval between
card swiping of the same card is less than the set value, the
card swiping is invalid.
6.
Oponal: Set Enable T&A Status switch to on to calculate
according to aendance status of the device.
Note
This funcon should be supported by the device.
7.
Set the related aendance me parameters as the following:
Start/End-Work Time
Set the start-work me and end-work-me.
Valid Check-in/out Time
On the me bar, adjust the yellow bar to set the metable
during which the check-in or check-out is valid.
Calculated as
Set the duraon calculated as the actual work duraon.
Late/Early Leave Allowable
Set the metable for late or early leave.
8.
Set absence related parameters.
Check-In, Late for
You can set the late me duraon for the employee who has
checked in but is late for work. If the employee exceeds the
required
me period, his/her aendance data will be
marked as absent.
Check-Out, Early Leave for
You can set the early leave
me duraon for the employee
who checks out earlier than the normal leave me, and
his/her
aendance data will be marked as absent.
No Check-in
If the employee does not check in, his/her aendance data
may be marked as absent or late.
No Check-Out
If the employee does not check out, his/her aendance data
may be marked as absent or early leave.
9.
Click Save to add the
metable.
10.
Oponal: Perform one or more following operaons aer
adding metable.
Edit Timetable
Select a metable from the list to edit
related informaon.
Delete
Timetable
Select a metable from the list and
click Delete to delete it.
8.9.3 Add Shi
85