When the funcon is enabled, the system will remind you to
delete records. The system will delete the rst 3000
aendance records when the memory reaches the
congured threshold, in order to save the new aendance
records. By default, the funcon is enabled. For details, see
Aendance Record Deleng Rule.
Language
Change the system language. Aer you change the system
language, the device will reboot
automacally.
4.
Press ESC and select Yes to save the
sengs and exit the page.
7.10.4 System Upgrade
You can upgrade the system online or locally. The system reads
the upgrading
le in the plugged USB ash drive or gain the
upgrading package from the plaorm to upgrade the device.
Steps
1.
Move the cursor and select System → Upgrade .
2.
Upgrade the system.
-
Local Upgrade: Plug the USB ash drive to the USB interface.
Press OK. The system will read the digicap.dav le and
upgrading automacally. Aer the upgrading is completed,
the device will reboot
automacally.
Note
•
The upgrading le should be in the root directory.
•
The upgrading le name in the USB ash drive should be
digicap.dav.
•
Do not power
o during the device upgrading.
•
Aer the upgrading is completed, remove the USB ash
drive.
-
Online upgrade: The system will gain the upgrade package
from the
plaorm to upgrade.
7.10.5 Restore
Sengs
Restore system parameters to factory sengs or default sengs.
Steps
1.
Move the cursor and select System → Reset .
2.
Press OK to enter the Reset page.
Figure 7-33 Reset Page
3.
Select Factory Sengs or Default Sengs.
Factory
Sengs
All parameters of the device will restore to the factory
parameters.
Default Sengs
37