HIKVISION DS-K1T804A Series - 8.2.2 Configure Basic Information

8.2.2 Congure Basic Informaon
You can add person to the client soware one by one and
congure the person's basic informaon such as name, gender,
phone number, etc.
Steps
1.
Enter Person module.
2.
Select an organizaon in the organizaon list to add the
person.
3.
Click Add to open the adding person window.
The Person ID will be generated automacally.
4.
Enter the basic informaon including person name, gender, tel,
email address, etc.
5.
Oponal: Set the eecve period of the person. Once expired,
the
credenals and access control sengs of the person will be
invalid and the person will have no authorizaon to access the
doors\oors.
Example
For example, if the person is a visitor, his/her eecve period
may be short and temporary.
6.
Conrm to add the person.
-
Click Add to add the person and close the Add Person
window.
-
Click Add and New to add the person and connue to add
other persons.
8.2.3 Issue a Card by Local Mode
If a card enrollment staon is available, you can issue a card by
local mode. To read the card number, you should connect the
card enrollment staon to the PC running the client by USB
interface or COM, and place the card on the card enrollment
staon.
Steps
1.
Enter Person module.
2.
Select an
organizaon in the organizaon list to add the person
and click Add to enter Add Person panel.
Note
Enter the person's basic informaon rst. For details about
conguring person's basic informaon, refer to Congure Basic
Informaon.
3.
In the Credenal → Card area, click +.
4.
Click
Sengs to enter the Sengs page.
5.
Select Local as the card issuing mode.
47