Steps
1.
Enter the Device Management module.
2.
Oponal: Click on the right of Device Management and
select Device.
The added devices are displayed in the list.
3.
Click Add to open the Add window.
4.
Select IP Segment as the adding mode.
5.
Enter the required
informaon.
Start IP
Enter a start IP address.
End IP
Enter an end IP address in the same network segment with
the start IP.
Port
Enter the device port No. The default value is 8000.
User Name
By default, the user name is admin.
Password
Enter the device password.
Cauon
The password strength of the device can be automacally
checked. We highly recommend you change the password of
your own choosing (using a minimum of 8 characters,
including at least three kinds of following categories: upper
case leers, lower case leers, numbers, and special
characters) in order to increase the security of your product.
And we recommend you change your password regularly,
especially in the high security system, changing the
password monthly or weekly can
beer protect your
product.
Proper
conguraon of all passwords and other security
sengs is the responsibility of the installer and/or end-user.
6.
Oponal: Check Synchronize Time to synchronize the device
me with the PC running the client aer adding the device to
the client.
7.
Oponal: Check Import to Group to create a group by the
device name.
Note
You can import all the channels of the device to the
corresponding group by default.
8.
Finish adding the device.
-
Click Add to add the device and back to the device list page.
-
Click Add and New to save the
sengs and connue to add
other device.
9.
Oponal: Click on Operaon column to view device status.
8.1.4 Add Device by EHome Account
43