HIKVISION DS-K1T804A Series User Manual

For access control devices supports EHome 5.0 protocol, you can
add them to the client by EHome protocol aer entering device
ID and key, if you have congured their server addresses, port
No., and device IDs.
Before You Start
Make sure the devices have connected to the network properly.
Steps
1.
Enter Device Management module.
The added devices are displayed on the right panel.
2.
Click Add to open the Add window.
3.
Select EHome as the adding mode.
4.
Enter the required informaon.
Device Account
Enter the account name registered on EHome protocol.
EHome Key
For EHome 5.0 devices, enter the EHome key if you have set
it when conguring network center parameter for the
device.
Note
This funcon should be supported by the device.
5.
Oponal: Check Synchronize Time to synchronize the device
me with the PC running the client aer adding the device to
the client.
6.
Oponal: Check Import to Group to create a group by the
device name, and import all the channels of the device to the
group.
7.
Finish adding the device.
-
Click Add to add the device and go back to the device list.
-
Click Add and New to save the sengs and connue to add
other device.
Note
Face pictures cannot be applied to devices added by EHome
account.
8.
Oponal: Perform the following operaon(s).
Device Status
Click on Operaon column to view
device status.
Edit Device
Informaon
Click on Operaon column to edit the
device informaon, such as device name,
device account, and EHome key.
Check Online
User
Click on Operaon column to check the
online users who access the device, such
as user name, user type, user's IP
address, and login
me.
Refresh
Click on Operaon column to get the
latest device informaon.
Delete Device Select one or mulple devices and click
Delete to delete the selected device(s)
from the client.
44

HIKVISION DS-K1T804A Series Specifications

General

Brand	HIKVISION
Model	DS-K1T804A Series
Category	IP Access Controllers
Language	English