SD Card Slot
Hillstone SG-6000-X7180 has an SD slot on the front panel for inserting SD storage card. SD
card stores the data of the Network Behavior Control log messages. So far, the highest capacity of
SD card for SG-6000-X7180 is 32GB.
To install an SD card, take the following steps:
1. Ensure that the write protection switch is off so that it can be written.
2. Face the front panel of the device.
3.
Insert the SD card with the metal contact side facing down and push it slightly into the
card slot. Do not push too hard with force to avoid damage to the slot or the card.
4.
Find the seal label in the accessory box and stick it onto the SD card slot to warn others
not to eject the SD card at will.
Notes: You need to back up the existing data in the SD card before inserting it into
the slot, as the system will automatically format the card in one minute.
To remove an SD card, take the following steps:
1. To safely remove the SD card, run the command exec detach sd0 on the CLI interface.
2. Face the front panel of the device.
Preface 95
To Next Page
Loading...