l SIOM: SIOM-P40-300, SIOM-P100-300, SIOM-P100D-300
l SWM: SWM-280
Notes:
l For SG-6000-X9180, when there is no QSM-300 installed, you can install
IOM or SIOM to process QoS (make sure that the device has installed the
iQoS license). If you install the IOM to process iQoS, the iQoS does not sup-
port the shaping mode. If you install the SIOM to process iQoS, iQoS is the
same as the iQoS realized by installing QSM.
l When is device is installed with both QSM and IOM, QSM takes effect pref-
erentially to process iQoS.
l For more information about the expansion modules, see Expansion Module
Introduction.
l For more information about installing expansion modules on SG-6000-
X9180, see Installing Expansion Modules of SG-6000-X9180. For more
information about removing expansion modules of SG-6000-X10800, see
Replacing an Expansion Module of SG-6000-X9180.
Hardware Parameters
Hardware parameters of SG-6000-X9180 are shown below:
Table 2-14
Table: SG-6000-X9180 Hardware Parameters
Parameter Description
Chassis 7U
Size (W×D×H) 440.0mm x 735.0mm（the depth of handle and lever not included) x
308.0mm
32
Preface
To Next Page
Loading...
Need help?
General