click of the lock stuck in the chassis. Verify that the panel of the power module is plain
with the chassis panel.
Installing an AC/DC Power Module of SG-6000-X8180
SG-6000-X8180 requires at least one (in the country or region where the standard voltage is
110V, two are recommended) 220V AC power modules or one -48V DC power modules. The
installation of two power modules is recommended to ensure the redundant backup of the power
modules. Mix insertion (one AC power module and one DC power module are simultaneously
inserted) is not supported.
The following steps takes AC power module of SG-6000-X8180 as an example to introduce how
to install an AC or DC power module. To install an AC power module, take the following steps:
Chapter 3 Installation 168
To Next Page
Loading...
Need help?
General