Rack Mounting Requirements
Make sure the rack is secured to the structure of the building. If the geographical area is subject to
earthquakes, bolt the rack to the floor. For maximum stability, you can secure the rack to the ceil-
ing brackets.
Unpacking
This section provides guidelines for you to unpack the device before installation, including:
l Unpacking the appliance
l Verifying parts received
Unpacking the Package of SG-6000-X10800
SG-6000-X10800 is wrapped in the wooden case. The wooden case consists of wooden panels,
steel edges, tongues and EPE. Besides the chassis, the wooden case also contains the accessory
box.
The wooden case is 830.0mm long, 620.0mm wide and 1035.0mm high. The total weight of pack-
aging materials and the hardware is 165.0kg.
Notes: The device is maximally protected inside the shipping wooden case. Do not
unpack it until you are ready to begin installation.
To unpack the package, take the following steps:
1. Move the shipping wooden case to a place as close to the installation site as possible, where
you have enough room to remove packages (you are suggested to use a forklift or cart).
2. Position the wooden case with the arrows pointing up.
Chapter 2 Installation Preparations 122
To Next Page
Loading...