4. Face the front panel of the chassis, identify the slot in which the module should be
installed.
5. If the slot is covered with a blank plate, loose its screws with a cross screwdriver and
remove the plate, see Replacing an Expansion Module of SG-6000-X8180.
6. Position the SIOM module so that its front side faces you. Make sure that the lever is on
the downside and the SIOM module is plain with the outside edge of the expansion slot.
Rotate the levers to outside, and slide the expansion module straight into the slot along the
guide rail.
7. When the lever head is inserted into the expansion slot, you should rotate the levers to the
front of the module and slide the SIOM module into the slot until you feel resistant.
8. Tighten the screws clockwise on the SIOM module with a cross screwdriver.
9. To install more SIOM modules, repeat Step 1 to 7.
Installing Expansion Modules of SG-6000-X7180
The device requires at least one SCM, one SSM and one IOM. Additional expansion modules are
added according to your needs.
Chapter 3 Installation 160
To Next Page
Loading...
Need help?
General