Hillstone SG-6000 X-Series User Manual

1. Make sure the power module will not be powered during the installation process.
2. Wear an electrostatic discharge (ESD) strap around your bare wrist and connect the strap to
an ESD point on the chassis. See ESD Prevention.
3. Face the back panel of the chassis.
4.
Position the power module in the direction shown. Make the gold finger on the
upside, and make the outline of the power module and the power slot even. Slide the
power module straight into the slot till it is fully seated in the chassis slot. You can hear a
click of the lock stuck in the chassis. Verify that the panel of the power module is plain
with the chassis panel.
Notes: To install an AC power module of SG-6000-X8180 , make sure that the
gold finger is on the upside!
Installing a Power Module of SG-6000-X7180
Installing an AC Power Module
To install an AC power module, take the following steps:
169
Chapter 3 Installation

Hillstone SG-6000 X-Series Specifications

General

Brand	Hillstone
Model	SG-6000 X-Series
Category	Control Unit
Language	English