Hillstone SG-6000 X-Series User Manual

l QSM: QSM-200, QSM-100
l IOM: IOM-16SFP-100 , IOM-4XFP-100, IOM-2Q8SFP+-200, IOM-2Q8SFP+, IOM-
8SFP+
l Bypass Modules: IOM-2SM-BE, IOM-2MM-BE
Notes:
l For SG-6000-X7180, when there is no QSM installed, SG-6000-X8180 can
process QoS with IOM (make sure that the device has installed the iQoS
license). In this case, the iQoS does not support the shaping mode.
l When is device is installed with both QSM and IOM, QSM takes effect pref-
erentially to process iQoS.
l For more information about the expansion modules, see Expansion Module
Introduction.
l The SSM module, QSM module and IOM module of SG-6000-X7180 are
divided into half width and full width. Only SSM-200, QSM-200,
IOM2Q8SFP+ -200, IOM-2Q8SFP+ and IOM-8SFP+ are full width mod-
ules. Other models are half width modules. The installation method of full
width modules and half width modules are different, see Installing Expansion
Modules of SG-6000-X7180.
Hardware Parameters
Hardware parameters of SG-6000-X7180 are shown below:
Table 2-32 Table: SG-6000-X7180 Hardware Parameters
Parameter Description
Chassis 5U
Preface 73

Hillstone SG-6000 X-Series Specifications

General

Brand	Hillstone
Model	SG-6000 X-Series
Category	Control Unit
Language	English