Copper Port
Hillstone SG-6000 X series supports copper ports. The MGT port of the SCM module supported
by SG-6000-X10800/X9180/X8180 is the copper port. Each Combo port on the front panel of
SG-6000-X7180/X6180/X6150 includes one copper port. The description of copper port attrib-
utes is listed below.
Table: Copper Port Attributes
Attribute Description
Connector
Type
RJ-45
Frame Format Ethernet_II
Ethernet_SNAP
Negotiation
Mode
10/100/1000Mbps autosensing
Full-duplex/Half-duplex
SFP Port
The modules supported by SG-6000 X series provide the SFP port (1GE). The Combo port on
the front panel of SG-6000-X7180, SG-6000-X6180, and SG-6000-X6150 can also be used as
the SFP port (1GE). The SFP port supports both the 1GE(SFP) transceiver module and the cop-
per SFP module. Select the module type based on your needs.
Table 2-50
Table: SFP Port Attributes
Attribute Description
Connector Type SFP
Frame Format Ethernet_II
Ethernet_SNAP
Negotiation Mode With the SFP transceiver
module
1000Mbps
102
Preface
To Next Page
Loading...