4.3 Integration Value Observation
54
These functions can be controlled by key operations or by communication commands.
Before Starting Integration
1. Verify that the clock is set correctly.
See "Clock" (p. 101)
2. Select the integration mode.
See 4.3.2 ( p.56)
3. Set the desired time control functions (interval, timer, and clock controls).
See 4.3.4 ( p.59)
Set "OFF" for time settings when integrating manually.
4. Make appropriate settings for saving to CF card, and for D/A output, as needed.
See "7.3 CF Card Formatting" (p. 106), "8.4 Using Analog and Waveform D/A Output Options (must be factory
installed before shipping)" (p. 132)
Starting, Stopping, and Resetting Integration
Start integration: press once
Stop integration:
* press again
Resets integration: press when integration
is finished
Always reset the inte-
gration values when
changing other settings.
* When timer or clock control
is enabled, integration stops
automatically at the specified
stop time.
• Integration start, stop and value reset cannot be performed on the Setting or File Operation
screens. These functions are available only on the Measurement screen.
• Remote control by USB or LAN communications can be performed using the same opera-
tions on the remote control application program screen.
See"Chapter 9 Operation with a Computer" (p. 141)
To Next Page
Loading...
