3. Confirm the slot number and the port number of failed mezzanine card. In
addition, record the value of WWN.
Select Emulex nnn line for the failed mezzanine card slot #, where nnn is
odd number, in Storage window by using ↓ and ↑ keys, and then press
Enter.
Note: A half wide server blade can install a mezzanine card in slot 2.
A full wide server blade can install two mezzanine cards in slot 2 and slot
4.
4. Write down the alphanumeric in Node Name line. Select Set Boot from
SAN, and then press Enter.
Select the setting of failed mezzanine card, Enable or Disable by using ↓
and ↑ keys, and then press Enter.
Configuring Emulex mezzanine card
7-33
Hitachi Compute Blade 500 Series System Service Manual
To Next Page
Loading...
