10. Press Esc key.
11. Select the port#1, and then press Enter key.
12. Repeat the procedures, step 8 and step 9.
13. Press Esc key until the following dialog is displayed.
14. Press Y to close the PXESelection Utility.
15. Press Ctrl + S key when the following prompt was displayed.
iSCSISelect Utility starts.
(Only when iSCSI is selected in Personality setting on one of the CNA
products, the line of iSCSI Initiator BIOS is indicated.
Only when FCoE is selected in Personality setting on one of the CNA
products, the line of FCoE BIOS is indicated.)
7-60
Configuring Emulex mezzanine card
Hitachi Compute Blade 500 Series System Service Manual
To Next Page
Loading...
