7 - 74
[Copy] button: Copies the content of the calibration condition selected, and make a
new calibration condition.
[Delete] button: Deletes the calibration condition selected from the Condition table
dialog.
The calibration condition applied to the displayed image and Default
cannot be deleted.
[Edit] button: The dialog shown in Figure 7.23-3 is displayed. And then, the [Comment],
[HV], [Mag], and [WD] of the calibration condition selected can be edited.
[Apply] button: Applies the condition that has been selected to the displayed image.
[Close] button: Closes the Condition table dialog.
[UP/DOWN] button: Permutes the order of the condition on the Condition table dialog.
The selected condition is moved up when clicking the [UP] button, and
it is moved down when clicking the [DOWN] button.
To Next Page
Loading...
