2 - 2
Initial Setup for MX7 Tecton
Following are steps you might take when setting up a new MX7 Tecton. Follow the links for further instruction for each step. Con-
tact Technical Assistance (page 16-1) if you need additional help.
Note: Installing or removing accessories should be performed on a clean, well-lit surface. When necessary, protect the work
surface, the MX7 Tecton, and components from electrostatic discharge.
Hardware Setup
1. Connect accessories e.g., hand strap (if necessary), trigger handle, etc.
2. Provide a power source:
• Insert a fully charged main battery.
• Connect a power cable (USB/Power or Serial/Power).
• Place the MX7 Tecton in a powered desktop or vehicle mounted cradle.
3. Press the Power key.
Software Setup
Hardware setup should be completed before starting software setup.
1. Calibrate Touch display.
2. Set Date and Time Zone.
3. Set Power Timers.
4. Set Speaker Volume.
5. Pair Bluetooth devices.
6. Set Wireless client parameters.
7. Set terminal emulation parameters.
8. Set AppLock parameters.
9. Set DCWedge parameters.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
