EasyManua.ls Logo

Honeywell MX7 Tecton - Power Connector Port; Battery Charger; Electrical; Temperature

Honeywell MX7 Tecton
354 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
15 - 5
Power Connector Port
Note: When an external power supply is used to power these products, the external power supply should be UL Listed, with
LPS or Class 2 outputs rated 12V, minimum 2 Amps.
The Power connector is located on the back of the vehicle cradle.
Battery Charger
Battery: MX7 Tecton Li-Ion 7.4V 2.2Ah battery with a 500 charge/discharge life cycle.
Electrical
Note: Battery packs may leak up to 1mA current through the battery contacts when left in a non-powered battery charger
charging pocket.
Temperature
Dimensions
Pin Signal Wire Color
1 Ground (CG) Green
2 Return (-) Blue
3 +12V (+) Brown
Parameter Minimum Maximum Note
Power Supply Input Voltage (V AC-IN) 100 VAC 240VAC Auto-switching
Power Supply Input Frequency (freq) 47Hz 63Hz
Function Minimum Maximum Note
Operating 0°C (32°F) +40°C / (104°F)
Battery Pack Charging 0°C (32°F) +40°C / (104°F) Battery packs will not begin charging when their inter-
nal temperature is outside this range.
Storage -20°C (-4°F) +70°C / (160°F) Unit is off.
Category Dimension
Weight 1.75 lbs / .79 kg
Length 12.25” / 31.1 cm
Width 5.25” / 13.3 cm
Height 1.5” / 4 cm
Plug Type IEC320 (3 prong, grounded)

Table of Contents

Other manuals for Honeywell MX7 Tecton

Related product manuals